Advertisement
PW90
The unit comes pre-programed from the factory at 5 minutes and should not need to be programed. But
depending on your customer you may want to change programing to suit their needs. The PW90 Ozone se�ngs
can be adjusted with the PW90 app, or on the display panel on the unit itself. NOTE: If the Ozone se�ngs are too
high, it can affect the taste and odor of the water.
PW90 Display panel:
1.
Enter program mode.
2.
Wave hand over the Hot bu�on un�l the cursor is res�ng on "Oxygen Injec�on"
3.
Wave hand over the Dispense bu�on to select "Oxygen injec�on"
4.
While in the "Oxygen injec�on" mode wave hand over the Hot bu�on to scroll through op�ons and Dispense
bu�on to make changes.
For example, please review illustra�on below: - To adjust the on �me, wave hand over the Dispense bu�on while
5.
the cursor is blinking over "On �me" un�l the desired �me is selected
•
To adjust the air purge �me, wave hand over Hot bu�on un�l "PAO �me" is blinking, wave hand over
Dispense bu�on un�l desired �me is selected
•
To adjust the interval/off �me, wave your hand over Hot bu�on un�l "off �me" is blinking, wave hand over
dispense bu�on un�l desired �me is selected
To adjust to ac�vate at �me of dispense, wave hand over Hot bu�on un�l "At dispense" is selected.
•
Wave hand over Dispense bu�on un�l desired �me is selected
PW90 APP:
1.
Enter the PW90 APP.
2.
Press the cleaning se�ngs tab
3.
Turn "Daily Ozone Cycle" into the ON posi�on
4.
Adjust desired se�ngs and press "set"
5.
Unit dispense light will blink purple to indicate se�ngs have
been changed.
Daily Ozone Settings
Programing the Ozone
Set Button
Advertisement
