Table of Contents
Advertisement
en | 26 | DAS 3000 S20
3
5
1
4
3
2
1
1
(1) Long cover in the rear slot
(2) Short cover in the right slot
(3) USB connecting cables for CCD cameras in the camera beam
(4) Cable clamp
(5) Opening in the laptop/table shelf
7. Guide the USB connecting cables through the open‐
(5)
ing
in the laptop/tablet shelf in such a way that
USB connecting cables do not hang down along the
right profile to the rollers.
If the USB connecting cables are not run through
the opening (5), they may be damaged because
of their length when the DAS 3000 S20 is moved.
---Separator---
4.9
Attaching the "Multi-Target Shop" box
to the DAS 3000 S20
The "Multi-Target Shop" box for safe storage of
calibration boards with magnetic attachment is
not included in the scope of delivery for the
DAS 3000 S20. The box can be placed in and fas‐
tened to the trolley of the DAS 3000 S20.
1. Place the "Multi-Target Shop" box
2. Secure the box with two knurled screws (2).
1 689 989 485 | 2020-08-01
4
5
4712005-49_shd
3
2
(1)
in the trolley.
2 2
1
(1) "Multi-Target Shop" box
(2) Knurled screws
---Separator---
4.10 Attaching the corner guards to the
calibration board (CTA 300-x)
(1)
Attach the corner guards
of calibration board CTA 300-x.
2
1 1
(1) Corner guards
(2) Bottom edge of calibration board CTA 300-x
---Separator---
4.11 Installing the reference board (CTA
400-x)
Use two screws to fasten reference board CTA 400-x
(1)
to the socket pin (2).
(1) Reference board (CTA 400-x)
(2) Socket pin
---
(2)
to the bottom edge
2
1
Robert Bosch GmbH
Advertisement
Table of Contents
