Table of Contents
Advertisement
2. Remove the single screw from inside the monitor base as shown below.
Figure 1-6. Removing the single screw and separating the monitor panel
3. Loosen the data and DC power cables between the monitor panel and the base to allow enough
slack to separate the monitor panel from the base.
4. Separate the monitor panel from the monitor base (spare part no. 296474-001).
CAUTION: Be sure the monitor front bezel is lying down on a soft area to prevent it from getting scratched,
defaced, or broken.
To replace the monitor panel back onto the monitor base, reverse this procedure.
Compaq TFT500 Flat Panel Monitor
1-7
Advertisement
Table of Contents
