Ethernet Settings - Intec ARGUS GigaBit Ethernet Manual

2.1 Ethernet Settings
Setting Explanation
Access parameters:
Phys. parameters:
Ethernet:
Switch on or off.
Auto-
negotiaion
If autonegotiation is enabled, a network card can independently determine
the correct transmission speed and duplex setting for the network port to
which it is connected and can then configure itself accordingly. In the case
of Ethernet, autonegotiation is based on Layer 1 of the OSI Model (in
accordance with the IEEE 802.3u standard). 
Default setting: on
For information on the off setting, see the next section page 9.
MAC address:
ARGUS

Display and selection of the MAC addresses.
The first two MAC addresses cannot be changed manually.
1. If the default MAC address is selected, the ARGUS will use its own
MAC address. Default setting: Default MAC address
2. If dynamic MAC address is selected, a different MAC address will be
used for each synchronization.
3. A third MAC address can be entered: Mark a line and then 
press .
<Edit>
2 Operation on an Ethernet access
ARGUS shows the last used or the storing
MAC address.
Move the cursor within the
line.
Delete the character
<Delete>
before the cursor
7