Makita UR002G Instruction Manual page 15

Adjusting the hanger position
For UR002G only
For more comfortable handling of the tool, you can
change the hanger position.
1.
Loosen the hex socket head bolt on the hanger
and slide it to a comfortable working position.
1
► 1. Hanger 2. Hex socket head bolt
2. Adjust the hanger position as shown in the figure
and then tighten the hex socket head bolt.
750 mm
1
(29-1/2")
750 mm
(29-1/2")
1 The hanger position from the ground
2 The cutting tool position from the ground
3 The horizontal distance between the hanger
and the unguarded part of the cutting tool
Correct handling of the tool
WARNING:
Always position the tool on your right-
hand side. Correct positioning of the tool allows for maximum
control and will reduce the risk of serious personal injury.
WARNING:
Be extremely careful to maintain
control of the tool at all times. Do not allow the tool
to be deflected toward you or anyone in the work
vicinity. Failure to keep control of the tool could result
in serious injury to the bystander and the operator.
WARNING:
To avoid accident, leave more
than 15m (50 ft) distance between operators when
two or more operators work in one area. Also,
arrange a person to observe the distance between
operators. If someone or an animal enters the
working area, immediately stop the operation.
2
2
100-300 mm
(3-15/16"-11-3/4")
3
CAUTION:
If the cutting tool accidentally
impacts a rock or hard object during operation,
stop the tool and inspect for any damage. If the
cutting tool is damaged, replace it immediately.
Use of a damaged cutting tool may result in serious
personal injury.
Correct positioning and handling allow optimum control
and reduce the risk of injury.
UR002G
UR003G
When using a nylon cutting head (bump & feed
type)
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To feed out the nylon cord, tap the cutting head against
the ground while rotating.
► 1. Most effective cutting area
15 ENGLISH
1