Recommended Hookup; Troubleshooting - Husky DPCN45 Use And Care Manual

Recommended hookup

1. The air compressor must be able to maintain a minimum
of 70 psi when the tool is being used. An inadequate air
supply can cause a loss of power and inconsistent
driving.
2. An oiler can be used to provide oil circulation through the
tool. A filter can be used to remove liquid and solid
impurities which can rust or gum up internal parts of the
tool.
3. Always use air supply hoses with a minimum working
pressure rating equal to or greater than the pressure from
the power source if a regulator fails, or 150 psi, whichever
is greater. Use 3/8 in. air hose for runs up to 50 ft. and use
3/8 in. quick coupler on the air hose.
4. Use a pressure regulator on the compressor, with an
operating pressure of 0-125 psi. A pressure regulator is
required to control the operating pressure of the tool
between 70 psi - 115 psi.
Quick
coupler
Quick
connector
CAUTION: The air compressor must be able to
maintain a minimum of 70 psi when the tool is being
used. An inadequate air supply can cause a loss of
power and inconsistent driving.
WARNING: Do not connect with an air compressor
which can potentially exceed 200 psi. As the tool may
burst, possibly causing injury.
Quick
Filter
Oiler
Air hose
connector
Quick
Regulator
coupler
14

Troubleshooting

WARNING: Stop using tool immediately if any of the following problems occur. Serious personal injury could result. Any repairs or
replacements must be done by a qualified service person or an authorized service center.
Problems
Air leaking at trigger
valve area.
Air leaking between
housing and nose.
Air leaking between
housing and cap.
Tool skips driving
fastener.
Compressor
Tool runs slow or has
loss of power.
Fasteners are
jammed in tool.
Possible cause(s) Corrective action
O-rings in trigger valve housing Replace O-rings.
are damaged.
Tighten screws.
Loose screws in housing.
Damaged O-rings. Replace O-rings.
Replace bumper.
Damaged bumper.
Loose screws. Tighten screws.
Damaged gasket. Replace gasket.
Worn bumper. Replace bumper.
Dirt in nose piece. Clean drive channel.
Dirt or damage prevent the fasteners Clean magazine.
or pusher from moving freely in
magazine.
Damaged pusher spring. Replace spring.
Inadequate air flow to tool. Checking fitting, hose, or compressor.
Worn O-ring on piston or lack of Replace and lubricate O-rings.
lubrication.
Damaged O-ring on trigger valve. Replace O-rings.
Air leaks. Tighten screws and fittings.
Cap seal leaking. Replace gasket.
Tool not lubricated sufficiently. Lubricate nailer.
Broken spring in cylinder cap. Replace spring.
Exhaust port in cap is blocked. Replace damaged internal parts.
Guide on driver is worn. Replace guide.
Fasteners are not correct size. Use only recommended fasteners.
Fasteners are bent. Replace with undamaged fasteners.
Magazine or nose screws are loose. Tighten screws.
Driver is damaged. Replace driver.
15
Please contact 1-888-HD-HUSKY for further assistance.
HUSKYTOOLS.COM