Fujitsu Siemens Computers AMILO Desktop S Series First-Time Setup page 45

Getting started
► Plug the receiver into a free USB port on your computer.
The radio connection will be established automatically.
Re-establishing the radio connection to the Keyboard Set if required
Normally a radio connection code is generated automatically and the Keyboard Set
is then immediately ready for operation. When the connection has successfully been
established the LED on the receiver lights up green. The LEDs on the keyboard and
mouse light up red if the battery voltage falls below 2.2 V.
If the connection is not established automatically, or if it breaks down, proceed as follows:
► Unplug the receiver from your computer and plug it in again.
► Place the mouse at a distance no greater than 30 cm from the receiver.
► Keep the left mouse button pressed for five seconds.
The LED on the receiver will flash green 4 times to indicate that the connection
to the mouse has been established successfully.
► Keep the Esc key on the keyboard pressed for five seconds.
The LED on the receiver will flash green 4 times to indicate that the connection
to the keyboard has been established successfully.
Skip forward and back buttons on the mouse
In addition to the right and left mouse buttons and a mouse wheel, your
mouse has two additional buttons (1):
12 - English
Esc .
10600985317, edition 1