Feit Electric STRP/2X2/4WY/LED Important Safety Instructions And Installation Manual page 4

Assembly
1
Turn the power OFF at the switch and fusebox
or the circuit breaker.
2
Open the fixture (AA) carefully (see Fig.1).
Fig. 1
AA
3
Use a screw driver to pop open your desired knockout on your
fixture. Install 1/2in conduit fitting (not included) as appropriate.
4
Lift the fixture (AA) up against the ceiling at the desired installation
location. Use a pencil to mark at the key holes where the plastic
anchors (BB) will be located (see Fig. 2).
x
AA
5
Use a small drill bit to drill 1/4 in. Pilot hole where you marked, then
insert the wall anchors if needed. Screw in provided mounting
screws (CC) on plastic anchors, leave 1/4 in. of screw out.
Fig. 3
1/4 in.
REV005
Fig. 2
x
CC
6
Install the fixture (AA) to the mounting surface by aligning the
key holes to the mountning screws (CC). Shift the fixture (AA) to
the narrow side of the keyhole to lock-in place (see Fig.'s 4 and
5). Tighten the Mounting screws (CC) to secure the fixture (AA)
to the mounting surface.
Fig. 4
Key Hole
NOTE: The ground wire will be used as a safety
wire to hold the lens up during the installation.
7
Connect the wire coming from the fixture to the wires coming
from J-box using wire connectors (DD) (see Fig. 6).
(Black - Line Voltage, White - Neutral, Green- Ground/Bare Copper)
8
Select desired color temperature using the slide switch on the
driver (3000K, 4000K, or 5000K) upon installation or select
"SWITCH" to control by wall switch (see Fig. 7).
9
Close the fixture then turn on the power at fuse or circuit breaker.
4
Please contact 1-866-326-BULB (2852) for further assistance.
Fig. 5
CC
AA
2
Figure
Fig. 6
DD
Fig. 7
SWITCH
5000K
4000K
3000K
WWW.FEIT.COM