SUMMER WAVES QUICK SET OVAL POOL User Manual page 26

Setup Instructions Continued
Inflating Instructions
CAUTION: Inflate by adults only. DO NOT overinflate, use a high-pressure air compressor to inflate, or exceed the
recommended Design Working Pressure. Inflate with cold air only.
1. Locate a clean area free of stones or other sharp objects to inflate the pool.
2. Inflate the air chambers following the numbered sequence (if any) slowly with a manual/foot air pump.
The adequate air pressure: make sure the pool is firm to the touch but NOT hard – there should be small folds
around the armrests, backrests and/or side edges, and below the cup holders (if any).
3. Close and press the inflation valves into the unit.
4. Check regularly to ensure the adequate air pressure during each use, especially on very hot or cold days.
IMPORTANT: BEFORE ADDING WATER TO YOUR POOL, YOU MUST INSTALL THE POOL WALL FITTINGS OR
ENTIRE FILTRATION SYSTEM FIRST. BEFORE ADDING WATER TO YOUR POOL, FOLLOW THE INSTRUCTIONS
BELOW.
If your pool included openings or you are going to purchase a filter pump system, position the Suction & Return fitting
locations so they are 3 - 6.4 m (10-21 ft) from the electrical outlet you plan to use for the pool pump. If your pool came
with Fittings - Install both the Suction and Return fittings to the pool wall before filling the pool.
Outside Pool Wall
Suction Fitting Base Suction Fitting Screen Service Plug
SUCTION FITTING
Please Note: The Black Rubber gasket (Fitting Gasket) should always be slid over the threaded plastic suction or return
fitting and be on the inside before the fitting is placed through the pool wall to make a watertight connection.
Make sure to put on both the Water Cap and the Service Plug while you fill your pool, or until you are ready to add a
filtration system.
Suction Fitting Screen
Suction Fitting Base
Inside Pool Wall
Inside Pool Wall
Flow Diverter
Suction Fitting Base
Flow Diverter Suction Fitting Base Service Plug
RETURN FITTING
Outside Pool Wall
11