Electrolux KOHHH000X User Manual page 22

22 www.electrolux.com
Step 6
Step 7
Step 8
Step 9
The screen-printing zone must face the
inner side of the door. Make sure that
after the installation the surface of the
glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.
11.4 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Turn off the oven. Wait un‐
til the oven is cold.
Back lamp
Step 1
Step 2
Step 3
Pull the door trim to the front to
remove it.
Hold the door glass panel by its
top edge and carefully pull it out.
Make sure the glass slides out of
the supports completely.
Clean the glass panels with wa‐
ter and soap. Dry the glass pan‐
els carefully. Do not clean the
glass panels in the dishwasher.
After cleaning, install the glass
panel and the oven door.
Before you replace the lamp:
Step 1
Disconnect the oven from
Turn the glass cover to remove it.
Clean the glass cover.
Replace the lamp with a suitable 300 °C heat-resistant lamp.
2
B
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Step 2
the mains.
1
Step 3
Put a cloth on the bottom
of the cavity.
A