Primus I35/50 Programming Manual page 8

SIZE OF IRONER
Choose correct size of ironer (according to production label):
Ironer with roller diameter 350 mm, roller length 1400 mm = 314
Ironer with roller diameter 350 mm, roller length 1600 mm = 316
Ironer with roller diameter 350 mm, roller length 2000 mm = 320
Ironer with roller diameter 500 mm, roller length 1600 mm = 516
Ironer or ironer with front/rear delivery with roller diameter 500 mm, roller length 2000 mm = 520
Ironer or ironer with front/rear delivery with roller diameter 500 mm, roller length 2500 mm = 525
Ironer or ironer with front/rear delivery with roller diameter 500 mm, roller length 3200 mm = 532
THE MACHINE TYPE
Choose „I" for normal ironer, „IF" for ironer with front/rear delivery with folder and „IR" for ironer with front/rear
delivery without folder. Other parameters follow according to this setting:
„I" – normal ironer
CONTROL
Set „OPL" for normal control or „Coi" for coin
control. When you select „OPL", the total time of
operation is displayed. When you select „Coi", the
following parameters are displayed:
OPERATION TIME FOR COIN 1 („C1")
Set the machine operation time (in minutes),
which corresponds to value of coin 1.
OPERATION TIME FOR COIN 2 („C2")
If the machine is equipped with coin meter for 2
different coin values, set the machine operation
time (in minutes) corresponding to value of coin 2.
MINIMAL TIME FOR THE MACHINE
START („St")
Set minimal time (it means minimal value of
inserted coins) necessary for the machine start.
The machine will not be possible to start unless
this minimal time is paid.
IRONING TEMPERATURE („TE")
Set required temperature of ironing roller.
SPEED („SP")
Set required ironing speed.
TOTAL TIME OF OPERATION („oH")
Displaying operation hours in hundreds (e.g. information 25 means 2500 hours of the machine operation).
TOTAL TIME OF HEATING („HH")
Displaying the total time of heating in hundreds of hours (e.g. information 18 means 1800 hours of heating).
FACTORY CODE („FC")
Displaying the factory code. Do not change the factory code !
508913C PUBLICATION DATE 25 AUG 2006.DOC
„IF" – ironer with folder
SETTING OF 1. FOLD („td")
Parameter serves to align the frontal edge of linen
with other folds. Higher value means longer frontal
edge and vice versa. Changing this parameter
according to type and thickness of linen enables to
reach optimal alignment of the frontal edge of linen.
LENGTH OF PULSE („PL")
It is setting from the manufacturing plant, necessary
for correct measuring of the fold width – do not
change!
FOLD CORRECTION („F1")
Acceleration at linen reversation - setting from
the manufacturing plant, necessary for correct
function of folder – do not change.
FOLD CORRECTION („F2")
Fold length reduction - setting from
the manufacturing plant, necessary for correct
function of folder – do not change
„IF" and „IR" IRONERS
CLOTHS DELIVERY („RD")
It permits/forbids selections of cloths delivery
direction by the button of cloths delivery direction.
PROGRAMMING MANUAL 7