Communications Commission Notice; Class A Equipment; Declaration Of Conformity For Products Marked With The Fcc Logo - United States Only - Rasilient AS316 User Manual

AS316 / AS316S User Guide

Communications Commission Notice

Part 15 of the Federal Communications Commission (FCC) Rules and Regulations
has established Radio Frequency (RF) emission limits to provide an interference-free
radio frequency spectrum. Many electronic devices, including computers, generate
RF energy incidental to their intended function and are, therefore, covered by these
rules. These rules place computers and related peripheral devices into two classes, A
and B, depending upon their intended installation. Class A devices are those that
may reasonably be expected to be installed in a business or commercial
environment. Class B devices are those that may reasonably be expected to be
installed in a residential environment (for example, personal computers). The FCC
requires devices in both classes to bear a label indicating the interference potential
of the device, as well as additional operating instruction for the user.
The rating label on the device shows which class (A or B) the equipment falls into.
Class A devices do not have an FCC logo or FCC ID on the label. Class B devices
have an FCC logo or FCC ID on the label. Once the class of the device is determined,
refer to the following corresponding statement.

Class A Equipment

This equipment has been assembled with components that comply with the limits for
a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause
harmful interference, in which case the user will be required to correct the
interference at personal expense.
Declaration of Conformity for Products Marked with the FCC Logo - United
States Only
This device complies with Part 15 of the FCC Rules Operation and is subject to the
following two conditions: (1) this device may not cause harmful interference that
may cause undesired operation. For questions regarding your product, please
contact your sales representative.
13