Wrench Storage; Stock Stop; Hand Held Mode - Princess auto pro point User Manual

8354789
Figure 19
Figure 22

WRENCH STORAGE

A built-in clamp A (Fig. 21) and two different rubber seats B, C (Fig. 21) are positioned on the rear of the base for
convenient storage of three adjusting wrenches supplied with your tool.

STOCK STOP

Screw the rod C (Fig. 22) into the vice base, and then tighten the nut D.
The stock stop A (Fig. 23) enables repeated cutting at the same length. To adjust the stock stop, loosen the socket
head screw B (Fig. 23) with the middle key put on the rear of the base.

HAND HELD MODE

The tool can be turned into a hand held band saw by simply following these steps.
1. Fix the cutting arm in the horizontal position by inserting the pin.
2. Loosen the two screws A (Fig. 24) on the locking block about one turn with the big key on the rear of the base.
3. Lift up the cutting arm with two hands, one holding the front handle and the other on back handle.
4. Place the cutting arm on a flat surface.
5. Remove the screws B (Fig.25) on the chip fence with the middle key put on the rear of the base.
6. Turn the chip fence upside down. Fix the chip fence on the block with the screws B (Fig. 25).
7. Then remove the two screws C (Fig.26) on the chip fence with the hex key and take off the wool pad device D.
8. While being bench saw, please ensure to put the wool pad device D (Fig26) back to the position.
For technical questions call: 1-800-665-8685
3-1/2" Band Saw
Figure 20
Figure 23
Figure 21
Figure 24
V 1.01
9