Blade Tension; Blade Tracking - Princess auto pro point User Manual

V 1.01
Figure 13
Figure 16
BOW DEPTH STOP
The stop A (Fig. 15) controls the depth to which the bow can fall and prevents the guard from contacting the base. If
required the stop can be adjusted by loosening the hex nut, turning the screw until the desired stop position is achieved
and re-tightening the hex nut.

BLADE TENSION

Rotate the knob clockwise until it touches the stop washer A (Fig. 16) to tighten the blade. Do not over-tension.
MOVABLE BLADE GUIDE AND GUARD
To ensure maximum safety and accuracy during cutting, the blade guard should be moved as close to the work piece
as possible. To achieve this,
1. Simply loosen the handle A (Fig.17)
2. Slide the blade guide assembly B (Fig. 18) to the desired location.
3. Then re-tighten it as shown in (Fig.19).

BLADE TRACKING

WARNING! Adjustment to Blade Tracking requires the Band Saw to be running while the blade cover is removed.
Therefore, extreme caution is recommended
Blade tracking has been pre-set at the factory and should require no adjustment. However should adjustment become
necessary it is suggested that it be carried out by a qualified serviceman. (fig 20)
8
3-1/2" Band Saw
Figure 14
Figure 17
Figure 15
Figure 18
For technical questions call: 1-800-665-8685
8354789