Parking The Unit; Park Brake - Operation - New Holland Workmaster 25 Tier 4B Operator's Manual

Parking the unit

Park brake - Operation

WARNING
Avoid injury! Always do the following before lubricating, maintaining, or servicing the machine.
1. Disengage all drives.
2. Engage parking brake.
3. Lower all attachments to the ground, or raise and engage all safety locks.
4. Shut off engine.
5. Remove key from key switch.
6. Switch off battery key, if installed.
7. Wait for all machine movement to stop.
Failure to comply could result in death or serious injury.
Mechanical transmission model
To park the tractor carry out the following procedures:
1. Depress the clutch pedal (1) and brake pedals (2).
Pull the hand throttle lever (3) rearward to reduce the
engine speed.
NOTE: Park the tractor on a level surface, if it is nec-
essary to park on a slope, place the transmission in
the lowest gear and place chocks or blocks in front
4 - OPERATING INSTRUCTIONS
1
NHIL12CT00891GA
or behind the tires depending on the direction of the
slope.
2. Place the shuttle shift lever (4) main gear shift lever
(5) in neutral and make sure the PTO switch (6) is in
the "OFF" position.
3. Push the HPL control lever (7) forward to lower imple-
ments (if equipped) to the ground.
4-25
W0047A