3M PELTOR WS MT73H74610WS6NA Series Manual

3M PELTOR WS MT73H74610WS6NA Series Manual

Litecom plus headset
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

TM
WS
LiteCom Plus
Headset
MT73H7*4610WS6NA

Advertisement

Table of Contents
loading

Summary of Contents for 3M PELTOR WS MT73H74610WS6NA Series

  • Page 1 LiteCom Plus ™ Headset MT73H7*4610WS6NA...
  • Page 2 3.7 V, 1800 mAh OPERATING TIME Expected operating time (according to standardized measurement) in room temperature Approximately 18 hours with ACK081 EXTERNAL INPUT 3M™ PELTOR™ Type J111-A 4-pole connector for external equipment RADIO Frequency range 462- 467 MHz Operation mode Half-duplex Antenna ¼...
  • Page 3 B:10 B:11...
  • Page 4 Headband MT73H7A4610WS6NA (F:13) (F:1) (F:2) (F:3) (F:18) (F:7) (F:4) (F:11) (F:5) (F:10) (F:15) (F:12) (F:16) (F:17) (F:14) (F:9) (F:8) (F:6) (F:21) Helmet attachment/Hardhat MT73H7P3E4610WS6NA Neckband MT73H7B4610WS6NA (F:20) (F:19)
  • Page 5 Fig.1 “Power on” Fig.2 Fig.3 Fig.4 Fig.5 “Power off”. ~0.5 s Fig.6 Fig.7 “Pairing complete” “Bluetooth ® paring on” “Connected” ~0.5 s x 2 Fig.8 “Channel” “Radio volume” “Ambient listening” “Phone volume” “Streaming volume” ~0.5 s “Bluetooth radio volume” ~0.5 s ®...
  • Page 6 532 g *3M strongly recommends individual fit testing of hearing protectors. If the NRR or SNR is used to estimate typical workplace protection, 3M recommends that the noise reduction value be reduced by 50% or in accordance with applicable regulations.
  • Page 7 FRS 7/GMRS 14 FRS 7 462.71250 FRS 8 FRS 8 467.56250 FRS 9 FRS 9 467.58750 FRS 10 FRS 10 467.61250 FRS 11 FRS 11 467.63750 FRS 12 FRS 12 467.66250 FRS 13 FRS 13 467.68750 FRS 14 FRS 14 467.71250 GMRS 1 FRS 15...
  • Page 8 Fig.9 “Sub-Menu” “VOX” “Sub channel” “Squelch” “Power” “Bluetooth pairing, ® For pairing press plus button” ~0.5 s ~0.5 s “English (Language)” Fig.10 “Set-Up Menu” “B C L O”” “Bluetooth streaming” ® “Max transmission time” “Bluetooth phone” ® “Automatic power off” “Bluetooth Multipoint”...
  • Page 9 3M™ PELTOR™ WS LiteCom Plus Headset 8-15 16-23...
  • Page 10: Intended Use

    • Do not charge batteries in temperatures above 45 °C WARNING (113 °F). • Use only 3M™ PELTOR™ Battery ACK081 charged with This hearing protector helps reduce exposure to hazardous cable 3M™ PELTOR™ AL2AI connected to a 3M™ PELTOR™ noise and other loud sounds. Misuse or failure to wear hearing...
  • Page 11: Fitting Instructions

    B:7 Insert the helmet attachment in the slot on the helmet and equipment, such as hard hat mounted hearing protection, snap it into place (B:8). please consult the NIOSH approval label or consult 3M B:9 Work mode: Press the headband wires inwards until you Technical Services for approved configurations.
  • Page 12 PTT or VOX. NOTE: Press (~0.5 seconds) the PTT button (F:16) (fig. 5) two NOTE: Use the following battery in this product: 3M™ times to activate VOX or to deactivate VOX. A voice message PELTOR™ ACK081 charged with cable 3M™ PELTOR™...
  • Page 13 Press (~2 seconds) the Bluetooth button (fig. 4). To return ® ® way radio support 3M™ PELTOR™ Push-To-Talk protocol. If you the call to the headset, press (~2 seconds) the Bluetooth ® have any questions, please contact your local distributor.
  • Page 14 1:19 Transmitting and receiving messages on a Bluetooth 2:8 Sub channel ® connected two-way radio Sets the sub channel according to lists (F) and (G) if it is enabled. Press the Bluetooth button (fig. 4) to transmit and release to (OFF, 1 –...
  • Page 15: Cleaning And Maintenance

    When used off-mode. Each change is confirmed by a voice message. regularly, 3M recommends replacing the foam liners and ear cushions at least twice a year to maintain consistent (“OFF”, “30 s”, “1 min”, “2 min”, “3 min”, “4 min”, “5 min”) Default: 3 min attenuation, hygiene, and comfort.
  • Page 16 NOTE: Use the following battery in this product: 3M™ 3M’s only obligation and your exclusive remedy shall be at 3M’s PELTOR™ ACK081 charged with cable 3M™ PELTOR™ option, to repair, replace, or refund the purchase price of such AL2AI connected to a 3M™...
  • Page 17: Uso Previsto

    Para más información y consultas, ponerse en el volumen de audio al nivel más bajo aceptable. contacto con el servicio técnico de 3M (los datos de contacto g. Por ejemplo, los auriculares, y especialmente las están en la última página).
  • Page 18 NIOSH o consultar con el servicio técnico de 3M para las NRR se basa en la atenuación del ruido continuo y podría no configuraciones aprobadas.
  • Page 19: Instrucciones De Manejo

    NOTA: Para recibir transmisión, el canal no debe estar bloqueado por transmisión mediante PTT o VOX. NOTA: Usar la batería siguiente en este producto: 3M™ PELTOR™ ACK081 cargada con cable 3M™ PELTOR™ NOTA: Para activar o desactivar VOX, pulsar dos veces AL2AI conectado a la fuente de alimentación 3M™...
  • Page 20 Los auriculares solo aceptan PTT 1:14 Cambio entre teléfono y auriculares por Bluetooth si el radioteléfono acepta el protocolo 3M™ ® Cuando hay una llamada activa, es posible transferir el audio PELTOR™ de presionar para hablar. Para consultas, ponerse en al teléfono en vez de usar los auriculares.
  • Page 21 Para finalizar una llamada telefónica, presionar brevemente Regula el nivel de volumen del sonido de radio entrante. (~0.5 segundos) el botón de Bluetooth (Desactivado, 1 – 6) Predeterminado: 3 (fig. 4). ® 2:4 Volumen de escucha ambiental (micrófonos 1:16 Marcación por voz dependientes de nivel) Para activar la marcación por voz, presionar sin soltar Ayuda para la protección del oído contra niveles de ruido...
  • Page 22: Limpieza Y Mantenimiento

    Cuando los 2:16 Apagado automático auriculares se usan con regularidad, 3M recomienda cambiar El apagado automático ajusta el tiempo transcurrido antes de los revestimientos de espuma y las almohadillas por lo que los auriculares se apaguen automáticamente si no hay...
  • Page 23 Se entrega con el producto como norma. D:1 Para quitar una almohadilla, introducir los dedos debajo NOTA: Usar la batería siguiente en este producto: 3M™ del borde de la misma y tirar de ella con fuerza hacia fuera. D:2 Quitar os revestimiento existente e insertar PELTOR™...
  • Page 24 única obligación de 3M y su remedio exclusivo será, por decisión de 3M, reparar, sustituir o reembolsar el precio de compra de tales piezas o productos con previa notificación oportuna por su parte del problema y justificación de que el producto se ha...
  • Page 25: Usage Prévu

    : MT73H7B4610WS6NA. a. 3M recommande un test de réglage individuel des INTRODUCTION protections auditives. Les études montrent que de nombreux Félicitations et merci d’avoir choisi les solutions de utilisateurs bénéficieront d’une réduction de bruit inférieure à...
  • Page 26 à fixer le altération du produit peut annuler l’approbation IP54 de ce casque et la motivation de l’utilisateur. Si l’indice NRR est produit. utilisé, 3M recommande de le réduire de 50 % ou conformément aux règlements applicables. A:1 Fréquence (Hz) REMARQUE A:2 Atténuation moyenne (dB)
  • Page 27 B:2 Ajustez la hauteur de chaque coquille. Pour cela, REMARQUE : utilisez le bloc-pile suivant dans ce produit : 3M™ faites-les glisser vers le haut ou le bas tout en maintenant le PELTOR™ ACK081 chargé à l’aide d’un câble 3M™ PELTOR™...
  • Page 28 ® REMARQUE : Appuyez (environ 0,5 seconde) sur le bouton protocole Push-To-Talk 3M™ PELTOR™. Pour toutes questions, merci de contacter votre distributeur local. PTT (F:16) (fig. 5) à deux reprises pour activer le mode VOX REMARQUE : Lorsqu’un troisième appareil Bluetooth...
  • Page 29 • Si vous entendez le message « Connexion Bluetooth ® • Si vous entendez le message « Connexion Bluetooth ® en cours, échec de la connexion echec_de connexion 1:19 Émettre et recevoir des messages sur une radio en cours, échec de la connexion echec_de connexion bluetooth bidirectionnelle active Bluetooth bluetooth...
  • Page 30 à appuyer sur le bouton PTT. Vous pouvez régler la sensibilité et [–] pour ajuster les réglages. à appuyer sur le bouton PTT. Vous pouvez régler la sensibilité de de l’émission à commande vocale. (« VOX désactivée eteint Pour quitter le menu de configuration, éteignez le casque. l’émission à...
  • Page 31: Nettoyage Et Entretien

    REMARQUE : utilisez le bloc-pile suivant dans ce produit : D:2 Retirez la/les rembourrage(s) en place et montez de 3M™ PELTOR™ ACK081 chargé à l’aide d’un câble 3M™ nouveau(x) rembourrage(s) en mousse. PELTOR™ AL2AI raccordé au bloc d’alimentation 3M™...
  • Page 32 3M™ PELTOR™ FL5602 PTT externe garantie expresse concernant une utilisation spécifique, la seule obligation de 3M et votre seul recours exclusif est, à Bouton PTT (appuyer pour parler) avec câble de connexion la discrétion de 3M, la réparation, le remplacement ou le pour la commande externe du mode émission depuis la radio...
  • Page 33 +375 172 10 41 85 95006 Cergy-Pontoise Cedex 3M New Zealand 3M Slovensko s.r.o. +33 0810 331300 94 Apollo Drive Obchodné zastupite stvo 3M Belgium N.V. / S.A. Rosedale, Albany Vajnorská 142, 831 04 Hermeslaan 7 3M Gulf Ltd. NORTH SHORE CITY Bratislava, Slovensko 1831 Diegem P.O.
  • Page 34 FP3858REVA cstechservice@mmm.com 3M Personal Safety Division 3M Center 3M is a trademark of 3M Company, used under license Building 235-2NW-70 in Canada. PELTOR is a trademark of 3M Svenska AB, St. Paul, MN 55144-1000 used under license in Canada.

Table of Contents