Advertisement
How do I prepare my XEA147 for set-up?
Take the XEA147 out of its box, remove the packing materials. Place the XEA147 on a flat stable surface,
close to a power outlet. Also insure it will not be exposed to direct sunlight, and is away from water (taps,
sinks, etc).
How do I clear the XEA147 to ready it for programming?
It is very important that you "initialise" the XEA147 correctly once you have removed it from the box, and
are ready to start programming. If you do not "initialise" the XEA147, it might not work correctly.
1. Insert the Mode key into the mode switch and turn it to the REG position.
2. Plug the AC adapter connector into the AC adapter jack, then plug the AC adapter into the wall
outlet.
This must be done without the batteries installed. If you have installed batteries; be sure to remove
them before you start this procedure.
After a few seconds, the register display should look as indicated below.
The register is initialised.
Note: This register does not have a sound function. No beep sound will be made when pressing
keys, this is normal, and is not a malfunction.
If the above steps do not happen as described, the initialisation has not been successful. If this is the
case: disconnect the register from the AC outlet, wait at least one minute, and then try again.
If there were any data from a previous programming attempt, they would have been cleared
XEA147BK and XEA147WH Frequently Asked Questions
Page 2 of 21
Advertisement
