Examine The Charger; Mount The Charger; Maintenance; Clean The Machine - GreenWorks 29692 Operator's Manual

EN
1. Put the battery pack into the charger.
• If the status LED flashes, remove the battery pack
from the charger for 1 minute.
2. Put the battery pack into the charger again.
• If the status LED shows correct, the battery pack is
good.
• If the status LED stays blinking, remove the battery
pack and disconnect the charger.
3. Wait for 1 minute and put the battery pack into the
charger again.
• If the status LED shows correct, the battery pack is
good.
• If the status LED stays blinking, the battery pack is
defective and it is necessary to replace the battery
pack.
6.2

EXAMINE THE CHARGER

If the battery pack does not charge correctly:
1. Examine the current of the power outlet with different
machines. Make sure that the outlet works.
2. Examine that the charger contacts are not short-circuited.
3. If the charger is not under usual room temperature, move
the charger and battery pack to a location where the
temperature is between 6 ˚C and 40˚C .
If you put the battery pack into the charger in warm or hot
environment, the charger LED light is red. Pull out the
battery pack and let the battery cool for approximately 30
minutes.
6.3

MOUNT THE CHARGER

1. Get the location of the wall to attach the charger.
2. Use 2 wood screws to attach the charger on the wood
studs.
3. Drill two paralleled holes 2 3/8" (60 mm) on center.
4. Use wall anchors and screws to attach the charger to the
drywall.
For charger 29692:
For charger 29292:
WARNING
English
If you do not use the battery pack and charger for a long
time, please remove the battery from the charger and pull
out the AC power plug.
7

MAINTENANCE

7.1

CLEAN THE MACHINE

Keep the air vent free of blockage, saw dust, and wood dust.
Do not spray, wash, or put the air flow in water.
• Clear the unwanted material out of the air vent with a
vacuum.
• Clean housing and the plastic components with a dry and
soft cloth.
Do not use strong solvents or detergents on the plastic
housing or components.
7.2

STORE THE MACHINE

• Remove the battery pack before you store the charger or
disconnect the charger.
6
NOTE
NOTE
IMPORTANT