HP Chromebook 11a Maintenance And Service Manual page 33

2. Remove the four Phillips M2.0 × 2.0 screws (1) that secure the system board to the computer.
3. Remove the two Phillips M2.0 × 2.0 screws (2) that secure the USB bracket to the system board.
4. Remove the USB bracket from the system board (3).
5. Remove the system board (4) from the computer.
IMPORTANT: When replacing the system board, be sure to remove the heat sink from the defective
system board and install it on the replacement system board.
Reverse this procedure to install the system board.
Component replacement procedures 27