Advertisement
Gently use your finger to press the ribbon back into the block. If you would use too much
pressure you will destroy the fragile contacts in the cable use a wiggling motion side to side
pressure to gently get the cable seated.
Once it has been inserted tape the shutter assembly so it can't be moved.
Also this is a good time to check that the modification was a success.
Remember with tehse shutter assemblys the P is actually the COMMON on a p41 and the C is
actually the POWER
With batteries in the camera short/Jumper between the C pad and the P pad and the camera
should turn on. Then short the P to the S and it should shutter a picture. I use tweezers to do this.
Never connect a power supply or battery to the shutter assembly's contacts as you will
destroy the camera
Once satisfied that the mod was successful Cover the solder pads with electrical tape.
Advertisement
