Mitsubishi Electric SEZ Series Technical & Service Manual page 15

[ II PART NAMES AND FUNCTIONS ]
Main menu Setting items
Operation Vane•3D i-See•Vent.
(Lossnay)
(Vane•Vent.(Lossnay))
High power
Comfort
Timer Timer
Weekly timer
OU silent mode
Night setback
Energy Restriction Temp.
saving
Energy
saving
HWE21010
Vane: Use to set the vertical air direction.
Louver: Use to set the horizontal air direction.
3D i-See sensor: This setting is available only for the air
conditioners that support easy setting function of motion
sensing air direction.
Vent: Use to set the amount of ventilation.
Use to reach the comfortable room temperature quickly.
• Units can be operated in the High-power mode for up to 30 minutes.
Manual Vertical air direction
• Sets the vertical airflow direction (vane) of each unit.
vane
angle
Horizontal air direction
• Sets the horizontal airfow direction (vane) of each unit.
On/Off Use to set the operation On/Off times.
timer • Time can be set in 5-minute increments.
* Clock setting is required.
Auto-Off Use to set the Auto-Off time.
timer • Time can be set to a value from 30 to 240 in 10-minute
increments.
Use to set the weekly operation On/Off times.
• Up to eight operation patterns can be set for each day.
• Two types of weekly schedules can be set.
* Clock setting is required.
* Not valid when the On/Off timer is enabled.
* 1ºC increments
Use to set the time periods in which priority is given to quiet
operation of outdoor units over temperature control. Set the
Start/Stop times for each day of the week.
• Select the desired silent level from "Normal," "Middle," and
"Quiet."
* Clock setting is required.
Use to make Night setback settings.
• Select "Yes" to enable the setting, and "No" to disable the setting.
The temperature range and the start/stop times can be set.
* Clock setting is required.
* 1ºC increments
Use to restrict the preset temperature range.
range • Different temperature ranges can be set for different operation
modes.
* 1ºC increments
Operation Use to lock selected functions.
locked • The locked functions cannot be operated.
Auto Use to get the units to operate at the preset temperature after
return performing energy-save operation for a specified time period.
• Time can be set to a value from 30 and 120 in 10-minute
increments.
* This function will not be valid when the preset temperature ranges
are restricted.
* 1ºC increments
Setting details
- 12 -
GB