Model no. 299-6913-2/Contact us 1-888-942-6686
FUSE REPLACEMENT
Get a new fuse from the storage, and remove the black rubber case.
1
To replace the fuse in the plug, twist off the upper cover.
2
Remove the faulty fuse and insert a new one.
3
Twist the upper cover back on the plug.
4
CLEANING
Use only mild soap and a damp cloth to clean the unit. Never let any liquid get inside the
casing. Never immerse any part of the unit in a liquid. Always keep the ventilation
openings clear.
TROUBLESHOOTING
Problem
Does not power on
The inflator is running
but inflator does not
inflate the object
The inflator takes too
long
Possible Cause
The two switches on unit are not set to correct positions.
The power cord is not connected securely to the vehicle's
cigarette lighter outlet.
The LED indicator on the power cord plug is off. The power
cord internal fuse is blown.
The power cord is damaged.
The vehicle's cigarette lighter outlet is dirty.
The vehicle's cigarette lighter outlet protective fuse is blown.
The vehicle's battery is dead.
The hose nozzle is not properly attached to the inflatable
object.
The inflator hose or inflatable object has a hole, allowing air to
escape.
The tire is completely deflated and has separated, allowing air
to escape.
The vehicle's battery voltage is too low.
The inflator has been running too long.
The inflator hose is damaged or is leaking.
The hose connector is not properly connected to the inflatable
object air inlet.
The inflator has been running too long.
15 A 250 V
Solution
Set the switches to their correct positions.
Press the plug inside the outlet and make sure the
LED indicator on power cord plug is on.
Replace the fuse.
Have a qualified service person repair cord.
Clean the outlet.
Refer to vehicle's operating manual for fuse
replacement instructions.
Recharge/replace the battery.
Secure the nozzle to the object.
Repair the hose or object.
Jack up the vehicle to release tire under vehicle's
pressure.
Recharge/replace the battery.
Rest the unit for 15-20 minutes.
Repair the hose.
Secure the nozzle to the object.
Rest the unit for 15-20 minutes.
7
TM/MC