Motomaster 299-6913-2 Instruction Manual page 7

6
Model no. 299-6913-2/Contact us 1-888-942-6686
Inflate the object to the desired pressure while monitoring the pressure level on the
6
pressure gauge.
After inflating the object, set the Inflator/Jack Switch to the Off (middle) position to
7
stop the inflator.
Remove the inflator hose from the object, and reattach the cap over the car tire's
8
threaded inlet valve stem.
Wrap inflator hose into a circle and store the hose in its storage.
9
Disconnect the power cord from vehicle's cigarette lighter, wrap the cord into a circle
10
and store in its storage.
OPERATING THE JACK SAFETY VALVE
In a rare occasion when jack's ram is stuck at UP position and does not come down when
setting the UP/DOWN switch to DOWN position, perform the following:
Remove the hex wrench from the accessory storage located on the side of the unit.
1
Remove the rubber cap over the safety valve on the top of the unit to be able to
2
access the safety valve hex cap screw.
Insert the hex wrench inside the safety valve hex cap screw and turn the wrench
3
counter-clockwise to loosen screw.
After jack is lowered, re-tighten the safety valve cap screw and replace the rubber
4
cap over the safety valve and store the wrench inside the accessory storage.
INFLATOR