Marker and firearm. For your own safety and to protect the image honored that you have chosen the Sniper as your marker of choice and hope you enjoy of the sport, always carry your Marker in a suitable Marker case or in the box in which using this high quality product.
SAFE - SAFETY “ON” Fig. 3.2 should be installed. Make sure your Consult the place where you purchased your Empire marker, or a recognized and marker is in “Safe Mode” when the marker is not being fired or when indicated to do so.
• Cock the marker by moving the pump handle back then forward. that anyone within range of the marker does the same. • Load quality Empire .68 caliber paintballs (leave some room for paintballs to move Pressurizing your Marker about, inside the loader).
(Fig 5.1). • Turning the rear velocity adjuster inward or clockwise will increase the velocity and The Empire Sniper paintball marker is equipped with an Auto-Trigger. To use the Auto- turning it outward or counterclockwise will decrease the velocity.
7. INSTALLING THE 10-ROUND FEED SYSTEM to make sure the Bolt is sealing forward of the feed neck, when the Hammer is released. Included with the Empire Sniper is a 10 round feeding system that replaces the stock Vertical Pump Handle clamping feed neck.
• Using a 5/54" Allen wrench, removed the Detent Cover screws. Once your Empire marker is unloaded and the air cylinder is removed, you can use a damp • Lift off the cover and remove the detents for cleaning or replacement as needed.
For your own safety and to protect the image assembly will slide off the back of the marker. of the sport, always carry your Empire marker in a suitable marker case or in the box in which it was shipped.
Empire will repair or replace with the same or equivalent model, without charge, any of its For warranty parts, service or information contact: Paintball Solutions • www.paintballsolutions.com products that have failed in normal use because of a defect in material or workmanship.