Table of Contents
Advertisement
OPERATING INSTRUCTIONS
Turning your LEGEND on/off
To turn your LEGEND on:
Press the button on the back of the frame for 1 second. The LED will light orange and stay orange for several seconds
after release of the button. The LED will then blink slowly green, normal mode, and blink slowly red if in competition
mode.
To turn your LEGEND off:
Press the button on the back of the trigger frame and hold for 2 seconds. The LED will blink red, let go of the button and
the LEGEND will turn off.
Turning your LEGEND eyes on/off
In order to "dry fire" the marker, the eye system must be bypassed or turned off. When the eye system is enabled, the
marker will not fire unless there is something present in the breech.
To bypass or turn off the eye system
1. Press the on/off button for 1⁄2 second.
2. The LED will slowly blink orange, indicating that the eye system has been bypassed.
3. Repeating this procedure will enable the eye system.
WARNING: The marker will fire when the trigger is pulled if the eye system is already bypassed or something is detected
in the breech.
Propellant Air/Nitrogen Supply
The LEGEND is designed to operate on air/nitrogen gas. This needs to be supplied to the LEGEND at an ideal regulated
pressure of 400 to 500 psi, using a suitable inline paintball regulator.
Bolt Removal
The bolt is manufactured from plastic, Delrin, so that it does not seize in the body due to the high operating speeds.
Eventually the bolt will show signs of wear depending on the usage and environment of use.
It is important that the bolt is kept free of dirt and grit, as this will cause accelerated wear.
We recommend that you clean the bolt after each use.
To remove the bolt
1. Pull the bolt pin up about a half an inch.
2. Then pull the bolt towards the rear of the marker.
To replace the bolt
1. Put the bolt back into the upper tube of the body. Make sure the bolt pin is aligned with the
groove in the lower ram
2. Push downward on the pin.
Battery Replacement
1. Turn the LEGEND off. (see previous page)
2. Remove the left grip panel by removing the two 6/32 screws.
3. Carefully remove the battery form the compartment.
4. Use a small screwdriver to remove the battery terminal from the battery.
5. Replace battery and be sure to mount the grip panel on before usage.
Advertisement
Table of Contents
