Terminology - Infinity LEGEND Operation And Maintenance Manual

Terminology

DWELL
Dwell is the amount of time that the Solenoid valve is energized. This is measured in milliseconds (1/1000 of a second).
th
The user can alter the Dwell only when in NORMAL mode. In COMPETITION mode, the Dwell menu item is not available.
Possible values are from 4.0ms to 50.0ms. The factory default is 10.0ms. Changes are made in 0.1ms units via the
trigger.
DEBOUNCE
Debounce is the amount of time the trigger switch must be stable in the up position before checking for another trigger
pull. Debounce is an electrical filter that filters out unwanted trigger pulls created by the micro switch. This time is
measured in milliseconds. The user can alter the Debounce only when in NORMAL mode. In COMPETITION mode,
the Debounce menu is not available. Possible values are from 1ms to 50ms. The factory default is 10ms. Changes are
made in 1ms units.
MROF CAP
The maximum rate of fire (MROF) cap sets the maximum cycling speed of the marker when eye mode 2 is used. Setting
this value to low will reduce the usable speed of the marker. Possible values are from 10bps to 30 bps. The factory
default is 15 bps. Changes are made in 1 bps units.
EYE POWER
The eye power controls how much power the eye system uses when transmitting inferred energy to the receiver. Setting
this value too low will cause problems if debris such as paint, dirt, etc. is between the transmitter and receiver. Setting
this value too high can cause problems with paintballs using clear shells. Possible values are from 1 to 20. The factory
default is 20. Changes are made in 1-unit increments.
FIRING MODE
The firing mode determines how the marker will fire. Possible modes are semi-auto, 3 shot ramping, and 3 shot full-auto.
The firing mode controls how the marker fires regardless of the other settings. Factory default is Semi-Auto. Changes
are made in 1-unit increments.
RESET
This option will reset ALL of the settings to the factory defaults. If you find that you are having problems remembering the
factory defaults, just use this option to reset your board and start over. The user reset can only be used while in NORMAL
mode.