Legend Eye Service; Exhaust Valve Stem Replacement - Infinity LEGEND Operation And Maintenance Manual

LEGEND Eye Service

The LEGEND uses a dual optical eye (beam break) system to detect when an object is present in the breech and ready to
fire.
1. The eye system is located under the same covers that holds the anti-double ball detent.
2. One 4-40 screw holds the eye cover to the body. Remove the screw and pop out the
eye and clean or replace as necessary.
��� ���� �� ������ �������
Exhaust Valve/ Cup Seal Stem Removal
The exhaust valve/ cup seal is consumable item that will eventually wear out.
Excessive wear of the exhaust valve is caused by dirty air or failure to keep it clean.
To replace the exhaust valve:
1. Unplug the solenoid from the
wiring harness.
2. Remove trigger frame.
3. Unplug both eye connector
4. Remove the front block set screw.
5. Remove front block.
6. Exhaust Valve assembly should fall out.
(Do not lose main spring)
7. Unscrew Black Exhaust Valve from
Valve Stem
To reassemble proceed steps 6 -1 in that order.
WARNING: Do not pull on eye wires.
Use a small pick or screwdriver to pop the
�������� ����
eye out of its slot. If necessary you can use
a small Allen Wrench to push the eyes out
from inside the breech of the gun.
����
�������� ����
������ �������
������� �����
Step 1