Advertisement
Gain Selection Adjustment
The middle switch on the back site can be set to
either low, mid or high gain (+10 dB). This switch
is used to raise the overall gain of the input for
lower output cartridges. When using cartridges
with very low output (less than 0.2 mV), it is
recommended that the high gain setting is
used. In all other cases the 0dB or +5dB setting
will sound the best.
Cartridge Loading Adjustment
Set the resistive load switch to 100Ω, 500Ω, or
845Ω,
depending
on
manufacturer's
recommendations
or
listening.
Any
value
between zero and 845Ω can be accomplished
by using a parallel cinch impedance jack.
Please ask your dealer for help if needed.
Daisy chain mode
BIZET
operates
one
tonearm
/
cartridge
combination. However, if you want to use
multiple sources, you can operate a second
(third ...) BIZET in a daisy chain mode. The signal
from the currently activated BIZET is transmitted
to the line stage without the need for input
switching. Doing so, you need to engage the
daisy chain switch and connect the preceding
outputs from another BIZET (or any other line
source) to the daisy chain input. If daisy chaining
is not used, use the upper position of the switch
(off).
7
Advertisement
