Remote Coding / Programming Routine; Programming 2 Way 4 Button Remotes; Remote Start Error Diagnostic - Firstech 2WT13R-SF User Manual

Remote Coding / Programming Routine

IMPORTANT: Every Firstech remote must be coded to the system prior to performing any
operations. All remotes must be coded at the same time.

Programming 2 Way 4 Button Remotes:

STEP 1: Activate Valet/Programming mode by manually turning the ignition key on and off (between
the Acc & On positions) five times within 10 seconds. The vehicle's parking lights will flash once with
the successful completion of this step.
STEP 2: Within 2 seconds after cycling the ignition for the 5
remotes or the (lock) button on 1 way remotes for a half second. The parking lights will flash once
to confirm the transmitter has been coded.

Remote Start Error Diagnostic

If the remote start fails to start the vehicle, the parking lights will flash three times immediately.
Following those three flashes the parking lights will flash again corresponding to the error table.
Number of
Parking Light
Flashes
1
2
3
4
5
6
7
8
9
10
We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or
call us directly.
Exiting Programming: Programming is a timed sequence. The parking
lights will flash twice signaling the end of programming mode.
Programming Multiple Remotes: After the confirmation flash given in
step 2, code additional remotes by pressing button (I) on 2 way
remotes or the (lock) button on 1 way remotes. The parking lights will
flash once confirming each additional remote. All compatible systems
can recognize up to 4 remotes.
Remote Start Error
Motor running or must first program tach
Key in ignition on position
Door open (manual transmission only)
Trunk open
Foot brake on
Hood open
Reservation off (manual transmission only)
Tach or tachless sensing failure
FT-DAS sensor shutdown
System is in Valet Mode
th
time, tap the Lock button on 2 way