Page 1
Fletcher-Terry Gemini Pro 100" Rail Cutter Instruction Manual...
Page 2
OWNER’S MANUAL Fletcher Gemini Pro Gemini Pro The Fletcher-Terry Company 65 Spring Lane • Farmington, CT USA 06032-3311 Tel 860.677.7331 • Toll-Free 888.888.5165 • Fax 860.676.8858 • customerservice@fletcher-terry.com • www.fletcher-terry.com Form ENG-040209...
TABLE OF CONTENTS INTRODUCTION.......................... i PRODUCT WARRANTY ....................i SAFETY FIRST ....................... ii OPERATING THE GEMINI PRO Unpacking Materials ....................1 Gemini Pro Components ..................1 Installing the Sight-Line Guide Strip ..............1 Attaching the Cutter to the Atlas Workbench .......... 2 Alternative Installation ................
.008" (0.2mm) straightness tolerance over the entire life of the machine—great for environments where extreme straightness is necessary. The Gemini or Gemini Pro is a perfect match with the Fletcher Atlas workbench, giving them the most even, level surface you can find, and that produces a clean, straight cut.
SAFETY FIRST! Please read through this manual before operating the Fletcher Gemini Pro. If after reviewing these pages you still have questions about using the machine, contact our Customer Service Department toll-free at 800.843.3826 in the United States. Outside the United States, call ++860.677.7331 or you may email us at customerservice@fletcher-terry.com...
Two (2) brackets for Gemini Pro 40", 60" or 80" (1m, 1.5m or 2.0m) Three (3) brackets for Gemini Pro 100" or 120" (2.0m and 3m) • One (1) Cutting Blade Magazine with Blade Stiffener •...
When not using the Atlas Workbench, put the Gemini Pro Cutter on a flat, even surface to ensure a straight cut. ♦ Note: Optional Table Mount Elevators are available to raise and lower the Gemini Pro on your work surface. Please contact Fletcher-Terry’s Customer Service Department at 800.843.3826, and reference Part #04-739 for more information.
Operation Installing the Blade There are three (3) components to the complete blade assembly unit: the Cutting Blade, the Magazine, and the Blade Stiffener. Make sure you have all three parts before continuing. When cutting material up to ¼" (7mm) thick, use the back stop position in the Magazine.
Page 9
Operation Cutting Board Materials 1. Position material under the Cutting Rail so the cutline matches up with the Guide Strip. 2. Position the Cutting Head to its farthest left position. 3. Place your left hand on top of the Cutting Head, and rotate the Cutting Head down so the Blade is depressed.
Check the guide below to troubleshoot some common issues during the use of your Gemini Pro Cutter. If the Troubleshooting Guide or the Frequently Asked Questions section listed below does not answer your questions, please contact our Customer Service Department at 800.843.3826, or send an email to customerservice@fletcher-terry.com. Symptom Probable Cause...
What is the maximum material thickness? The maximum thickness is ½" (13mm). Replacement Parts List To order Replacement Parts, contact Fletcher-Terry’s Customer Service Department at 800.843.3826 in the United States. Outside the United States, call ++860.677.7331 or go to the . ...
Common Consumables and Accessories Part Description Part Number Blades (Box of 100) 05-004 Blade Magazine Assembly 04-783 Gemini Pro Table Mount Elevators 04-739 Yellow Polyfoam Grip Strip 17-800 Blade Stiffener Assembly 17-551 Bumper &...