Nokia 3806 Service Manual page 72

and DUTUSB port, see "Hardware Connection".
ComPort = above 2
depend on the port number in "Device manager" of PC);
Baudrate=115200
default setting,
3.1.2 [Call Box]
the section is to select the radio communication test set and set its primary address, see below:
Type=2 (1:cmu200,2:hp8960)
Address=14
3.1.3 [PS]
the section is to select the power supply type and set its address and voltage if control by remote;
Type=0;
0:no, 0: indicates the power supply is used without GPIB remote, PS, 1:E3631A, 2:HP66309,
3:HP66311, 4:Keithley2306, 5:Keithley2304
Address=5
NormalVoltage=3.7
LowVoltage=3.2
For Low Battery Calibraton
HighVoltage=4.2
For High Battery Calibration
3.1.4 [cable loss]
The section is to set the using RF cable's loss;
3.1.5 [Test item]
Item = 1
The Item is always set to 1;
3.2 Sysconfig.ini
In the file, only "[CaliItem]" section is required to select item to calibrate; other Sections include test
parameters and test specification, which can not be changed.
3.2.1 [CaliItem]
Page 3-44
COMPANY CONFIDENTIAL
Copyright © 2009 Nokia. All rights reserved.
RM-583
Service Software Instruction
Issue 1