Nokia RH-37 Series Service Software And Tuning Instructions page 58

RH-37
Service Sofftware and Tuning Instructions
Adjust DAC Values for all power levels according to the target values:
TX PA Mode
High
The power levels may differ from the target power levels mentioned in Phoenix.
Make sure that the output power for Power Level 5 is equal or lower than 1dB below the
saturation output power. Determine the saturation power by setting the DAC value to its
maximum, for example, adjust the DAC Value to 32.3dBm for Power Level 5 if the satura-
tion output power is only 33.3dBm.
Check if all levels match the target values, correct if necessary and then press < Save &
Continue >.
Tx power level tuning GSM900 in EDGE mode
On the popped up window press ok.
The setup should now look like this:
Adjust DAC Values for all power levels according to the target values.
Page 58
Power level
5
15
19
Base level
Nokia Corporation
Target power (dBm)
32.5
13
5
-27
Nokia Custome Care
Issue 1 07/04