Nokia RH-37 Series Service Software And Tuning Instructions page 51

RH-37
Nokia Custome Care Service Sofftware and Tuning Instructions
If a radio communication tester (CMD 55, CMU 200, HP 8960, MT 8801) is used, assure
that <continuous mode> is switched on and <modulation> switched off.
Compensate for external RF cable and test jig losses.
Make sure that the <Input Signal Level (dBm)> field is set to -60 [dBm].
Press the <Start> button in the <Rx Band Filter Compensation> window.
The setup should now look like this:
(The example below shows a screen shot in GSM900!)
Set the RF signal generator as indicated in the pop-up window on the screen.
Press OK.
Continue tuning steps 2 to 9 following the instructions for power level and signal fre-
quency input.
Press OK after each step.
Note the limits as specified in the table below.
Press Save & Continue
Nokia Corporation
Issue 1 07/04 Page 51