Nokia 9210 Repair Hints page 7

Hide thumbs Also See for 9210:

Table of Contents

Customer Care Europe & Africa

SCCE Training Group

Flash menu with modified RAE3.ini file

After erasing the emulated eeprom, part of the XIP flash D353, the display shows contact service.

Now flash the phone without marking erase only.

After flash update set Full Factory and Accessory

(for Accessory see also chapter 4 "Connection with

any kind of accessory not possible") under menu

software/ Set Factory values (See picture below),

also rewrite product code and HW-ID.

Rewrite IMEI and SIMlock data if the procedure is permitted to you and tune the phone

If the erase only procedure not works change the D353 flash.

After changing the D353 Flash EEPROM, flash the phone. If the SW update was successful, make a full factory and Accessory

set, then rewrite the product code and the HW-ID. After that, rewrite IMEI and SIMlock data.

If the sw update is not successful, probably D300 MADLINDA is faulty. Up to HW 4.00, the D300 is not changeable because of

underfill. From HW-ID 4.23 with OSP, the MADLINDA is changeable. (See SB-027)

(Note! Everytime when it is necessary to change the D353 EEPROM or erase the EEPROM, a Full Factory set and

Asseccory set must be done!

Note! Rewrite SIMlock and IMEI data by use of NOKIA SECURITY PASSWORD and make a SW-update again, if the

procedure is permitted to you. (See SB–037)

CONFIDENTIAL

RAE-3

13.03.2002

Checked by:

Customer Care Training Group

7 (17)

Repairhints

Version 2.0 Approved

Choose

Erase Only

to reset

the flash D353

Approved by:

SCCE

Table of Contents

Rae-3