Raymarine E66008 Owner's Handbook Manual page 44

38
CAUTION:
Do not proceed if the hull temperature is below 60° F (15° C) since
the cure time of the casting epoxy will be greatly extended.
4. If the hull temperature is above 60° F (15° C), mix a half cup of
Hull thickness
Figure 2-18:
5. Proceed with step 7 of Installation on page 34.
All manuals and user guides at all-guides.com
casting epoxy stirring carefully to avoid trapping air in the mix-
ture.
Pour this around the housing until the cavity is full. Allow the
casting epoxy to set for at least 1 hour.
100 mm(4 in)
Installation in a Cored Fiberglass Hull
Transducers for Fishfinders
Transducer assembly
Inner skin
Core
Outer skin
Fill with casting epoxy
D5006-2