Fav; Teletext; Zoom; Troubleshooting - König Electronic SAT-SDHD50-KN Manual

7.13 FAV

1. Press FAV key to pop up the favorite group window.
2. Press
Press PR+, PR- keys to select the channel up or
down. Press OK key at the selected channel to view it
in full-screen mode. Press MENU or EXIT key to exit.
3. If there is no favorite channel, system will inform "No
FAV Channel!" when pressing the FAV key.

7.14 Teletext

Press TXT key to open the Teletext on the screen. If there is no Teletext, the system will inform
"No Teletext Data". Press EXIT key to exit.

7.15 Zoom

1. Press ZOOM key to switch between Zoom*1, Zoom*2, Zoom*3, Zoom*4, Zoom*5, Zoom*6,
Zoom*8, Zoom*12, Zoom*16.
2. In zoom mode, press PR+, PR-
3. Press MENU or EXIT key to exit

TROUBLESHOOTING

Problem
The display on the front
panel does not light up.
No sound or picture, but
the front panel shows red
light.
No sound or picture.
Bad picture / blocking
error.
The picture is not shown
on the screen, when
switching on.
There is interference
on your digital satellite
channels, an existing
terrestrial channel or
video signal.
The remote control is not
working.
keys to select the favorite group.
Possible causes
Main cable is not connected.
The receiver is in standby
mode.
The satellite dish is not pointing
at the satellite.
No signal or weak signal.
The satellite dish is not pointing
at the satellite.
Signal is too strong.
Satellite dish is too small.
LNB noise factor too high.
The LNB is faulty.
The system is connected by
RF leads.
The system is connected by RF
leads and the output channel
of the receiver interferes with
an existing terrestrial channel
or Video signal.
Battery exhausted.
keys to move the cursor up, left, right, down.
Check that the main cable is plugged into
the power socket.
Press the standby button.
Adjust the dish. Check the signal level in
the Antenna Setup menu.
Check the cable connections, LNB and
other equipment connected between the
LNB and the receiver, or adjust the dish.
Adjust the dish.
Connect a signal attenuator to the LNB
input.
Change to a larger dish.
Change to an LNB with lower noise factor.
Change the LNB.
Check the UHF channel fixed in your
system and tune the UHF channel
properly.
Change the receiver output channel to
a more suitable channel, or connect the
system by SCART leads.
Change the batteries.
27
What to do