Uberhaus HPS-C-GH Operator's Manual page 7

Step 4 – Guard Assembly
Place Guard on the Burner through the Emitter screen.
Put the ends of the Guard into the holes of the Burner.
Step 5 – Reflector Assembly
Insert a washer in each
60mm pin.
Fasten the reflector with 3pcs castle nuts.
Step 6 – Gas Tank Assembly
You must provide propane gas and propane cylinder.
Use a standard 1.02 lb. propane cylinder only.
Storage of an appliance indoors is permissible only if the
cylinder is disconnected and removed from the appliance.
A cylinder must be stored outdoors in a well-ventilated area
out of the reach of children. A disconnected cylinder must
have dust caps tightly installed and must not be stored in a
building, garage or any other enclosed area.
Standard 1.02 lb. tank
The pressure regulator supplied with the appliance must
be used.
The installation must conform with local codes, or in the
absence of local codes,with National Fuel Gas Code,
ANSI Z223.1/NFPA54, Natural Gas and Propane Installation
Code, CSA B149.1, or Propane Storage and Handling
Code, B149.2.
Only a cylinder marked "propane" can be used.
Certain materials or items, when stored under the heater,
will be subjected to radiant heat and could be seriously
damaged.
6
Insert reflector through the
pins and on the washers.
A dented, rusted or damaged propane cylinder may be hazardous
and should be checked by your cylinder supplier. Never use a
propane cylinder with a damaged valve connection.
The propane cylinder must be constructed and marked in
accordance with the specifications for LP gas cylinders of the
U.S. Department of Transportation (DOT). or the Standard for
Cylinders, Spheres and Tubes for Transportation of Dangerous
Goods and Commission, CAN/CSA-B339.
Provided with a listed overfilling prevention device.
Provided with a cylinder connection device compatible with the
connection for the appliance.
The cylinder used must include a collar to protect the cylinder valve.
Never connect an unregulated propane cylinder to the heater.
Turn off the control knob of the burner.Attach the 1.02 lb.
propane cylinder to the regulator(rotate the propane cylinder
clockwise on the regulator until tight.).
Close the door plate and lock it with the handle.
The cylinder must be disconnected when the appliance is not used.
Storage of an appliance indoors is permissible only if the cylinder
is disconnected and removed from the appliance.
An appliance may be installed in a shelter of the following type:
(a) With walls on all sides,but with no overhead cover.
(b) Within a partial enclosure which includes an overhead cover
and no more than two side walls. These side walls may be
parallet, as in a breezeway, or at right angles to each other.
(c) Within a partial enclosure which includes an overhead cover
and three side walls, as long as 30 percent or more of the
horizontal periphery of the enclosure is permanently open.
(a) Do not store a spare LP-gas cylinder under or near this appliance;
(b) Never fill the cylinder beyond 80 percent full;
(c) Place the dust cap on the cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cape on the
cylinder valve that provided with the cylinder valve. Other type of
caps or plugs may result in leakage of propane.
Replacement pressure regulator must be that specified by the
appliance manufacturer.