Advertisement
WIRING
(as shown on page 1)
Connect the DIN connection cord (Spin)
Isolator unit (GI-200).
Procedure To Mount The CD Changer Commander unit
(Using double sided tape)
1. Determine where the commander unit will be located.
2. Be sure that the mounting surface where the commander unit will be located, is
clean and dry.
3. Remove the protective paper from the back of the two sided tape.
4. Apply the commander unit to the desired location.
After completing all connections, be sure that the accessory and CD changer power is
off. Then press the RESET button on the commander unit.
RESET BUTTON
A Reset button @ is located on the front panel of the unit which must be activated with a
pen tip or other thin object as it is recessed to prevent accidental engagement.The
reset circuitry is provided to protect the unit's microprocessor and laser pick-up system
and should only be activated under the following circumstances:
1. Initial installation after all wiring is completed.
2. If abnormal disc operation is encoutered, the reset button may be pressed to clear
the system and return to normal operation.
to the FM Modulator (FM-200) or Ground
Advertisement
