Table of Contents
Advertisement
7. CONTROLS
CONTROL
BEZEL
ROLL-OUT
SWITCH
GAS
VALVE
Figure 27. Location of Controls (View One)
DRAIN
PLUG IN
REAR
HEADER
Figure 28. Location of Controls (View Two)
Control Panel Removal
1. Remove screw from front door. Set aside door for
serviceability.
2. Remove (4) screws from sides of control panel.
3. Rotate control panel down until panel stops. Do not
force.
APPROVED
TEMP SENSOR
HL1 - HIGH LIMIT
HL2 - HIGH LIMIT
T&P
GAUGE
FLOW
SWITCH
PRV
PROTEK
SHIELD
ASSY
F10640-6
PILOT
F10640-3
UNCONTROLLED DOCUMENT IF PRINTED
NOTE: Caution must be used to not damage controls
or wiring.
Figure 29. Knurled Screw Location
Control Adjustments
The pool heater touchpad, located on the upper front panel
of the heater, allows the user to select either POOL or SPA
operation, and to adjust the setpoint temperature. The LCD
display window indicates the mode (OFF, SPA, POOL)
and the actual water temperature. A manual power switch
provided below the touchpad turns the control power ON
or OFF. See Figure 30.
TEMP ADJUST BUTTONS
LCD DISPLAY
Figure 30. Control Adjustment
Mode Button
The MODE button is used to select POOL or SPA operation.
It also allows the user to turn the heater off electronically,
allowing the LCD to remain energized and to continue
showing the actual water temperature.
Temp Buttons
If the heater is in POOL or SPA mode, the desired water
temperature (SETPOINT) will be displayed and may be
adjusted using the UP or DOWN buttons.
KNURLED
SCREW
F10646-9
MODE BUTTON
TEMP
MODE
ON
OFF
23
Advertisement
Table of Contents
