Advertisement
OPERATION
6
NOTE: The carpet washer should be in the upright position when using the hose, deactivating the brush.
Do not saturate your upholstery.
The clean water tank will need to be filled with Hoover carpet cleaning solution and water before use.
Using the wash tool
Lift hose connection
Push and twist hose
port cover and line
connector clockwise into
up hose connector.
hose connection port.
Plug into mains, press
Press trigger on hose to
the on/off pedal to
release solution/water.
switch on.
TIP: Use the carpet washer or hose to pick up spills before washing and cleaning the area.
Push and twist water
Slide wash tool over tab
supply tube connector
at end of hose until it
onto solution tube port.
clicks into place.
Squeeze trigger on the
forward stroke, release
trigger on backward stroke
to recover solution/water.
IMPORTANT: Empty and rinse out clean and dirty water tanks and leave to air dry before
replacing. Do not leave solution and water stored in the tanks between uses.
Emptying the dirty water tank
Unclip and release the
Lift to remove the dirty
dirty water tank handle.
water tank.
CAUTION: Always unplug the carpet washer and remove all tanks before performing any
maintenance/troubleshooting checks.
Fitting the dirty water tank
Tilt main body of carpet
Lower dirty water tank
washer backwards.
onto base of carpet
Hook nozzle of dirty
washer and push
water tank under base
into place.
of machine.
TIP: The dirty water tank should be flush with the base. If it's not, this will result in poor water pickup.
OPERATION
Empty dirty water over
Turn the dirty water
the sink. Rinse dirty
tank cap anti-clockwise
water tank under water
to remove.
to remove dirt/debris.
Make sure the hose
connection port cover
is closed. Suction will
be lost if the cover
remains open.
7
Advertisement
