Cardo Systems PRO1 User Manual page 17

Table of Contents

Advertisement

Notices
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part responsible for
compliance could void the user's authority to operate the equipment.
15.105 (b)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
· Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF exposure
compliance. The antenna used for this transmitter must not transmit simultaneously with any other
antenna or transmitter, except in accordance with FCC/IC multi-transmitter product procedures.
Instructions concerning human exposure to radio frequency electromagnetic fields - to comply with
FCC Section 1.310 for human exposure to radio frequency electromagnetic fields, a distance of at
least 2 cm. between the equipment and all persons should be maintained during the operation of the
equipment.
Industry Canada (IC) FVIN: V1.0.0
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
that may be received or that may cause undesired operation.
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
IC RF Radiation Exposure Statement:
This equipment complies with the RSS-102 exemption from routine RF exposure evaluation for use in
an uncontrolled environment.
European CE Notice
17 |
P a g e

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PRO1 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents