Loading The Cable Feeder - Greenlee 6810-22 Instruction Manual

Setup (cont'd)

Loading the Cable Feeder

Select either End Loading method or Side Loading
method. Then proceed to the "Loading Cable" section.
End Loading Method
Pinch points: Grasp the middle of the handle.
Failure to observe this precaution may result in injury.
1. Release the ratchet mechanism by pushing down
on the upper drive handle while rotating the top of
the handle toward you.
2. Lift and pivot the upper drive unit back until it
contacts the stops.
3. Rotate the cable divider out and up.
Greenlee Tools, Inc.
Side Loading Method
1. Release the ratchet mechanism by pushing down
2. Remove the two clevis pins.
3. Unplug the upper drive unit motor.
4. Lift the upper drive unit out of the cable feeder.
5. Remove the cable divider.
Push down
on handle
while rotating.
9
6810-22 Ultra Cable Feeder
on the upper drive handle while rotating the top of
the handle toward you.
The upper drive unit is heavy and requires more than
one person to lift.
Failure to observe this precaution may result in injury.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Push down
on handle
while rotating.
Cable divider