Securing The Cable Feeding System - Greenlee 6810-22 Instruction Manual

Setup (cont'd)

Securing the Cable Feeding System

Select either the Stiff-Arm Boom method or the Anchor
method to secure the cable feeder.
Stiff-Arm Boom Method
Insert one end of a length of 2" rigid or IMC conduit into
the receptacle on the back of the cable feeder. Slip the
tee (supplied with the cable feeder) over the other end
of the conduit. Slide a second length of 2" rigid or IMC
through the tee. Push the cable feeder and stiff-arm
boom up against the reel stands.
Note: If feeding cable has been removed from the reels,
set the stiff-arm boom against a step, curb, door thresh-
old, stake driven into ground, etc.
Greenlee Tools, Inc.
Anchor Method
Use 3/8" - 1/2" anchors (purchased separately) through
the four anchor pads to stabilize the cable feeder.
Stiff-Arm Boom against Reel Stand
2" Rigid
IMC
tee
2" Rigid
IMC
Stiff-Arm Boom against Step
8
6810-22 Ultra Cable Feeder
Cable
Feeder
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070