Features; Transportation - Greenlee 6810-22 Instruction Manual

Features

• Wide tire grip accommodates:
– 8 x 250 MCM cable
– 6 x 500 MCM cable
– 5 x 750 MCM cable
• Dividers prevent tangling of cables
• Ground Cable Separator ensures traction on smaller
diameter cable
• Variable speed control to match the speed of most
cable pullers
• Quick Squeeze Adjustment accommodates indi-
vidual cables from 6.5 mm to 89 mm (1/4" to 3-1/2")
diameter
• Top loading or side loading
• Hand-held pendant control switch
• Twin drive traction wheels for optimum pulling power
• Low-speed DC motors provide quiet operation
• Efficient permanent-magnet motor design requires
little power
• Maintenance-free chain drive
Greenlee Tools, Inc.
6810-22 Ultra Cable Feeder

Transportation

To transport the cable feeder, pull the telescoping
handles out until they stop. If transporting over a
smooth surface, lift up on the handles to extend the
retractable caster. Quickly set the feeder down after the
caster swings out. To retract the caster, lift up on the
handles and quickly set the feeder down after the caster
swings back in.
If hoisting, attach slings only to the main frame. Feed
lifting sling all the way through the frame underneath the
front cable guides as shown.
Do not attach lifting slings to the upper drive unit.
The drive unit will break loose and the cable feeder
will fall.
Failure to observe this warning could result in severe
injury or death.
Upper Drive Unit
(shaded area)
6
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Lifting
sling