Welbilt MULTIPLEX FreshBlender Instruction Sheet page 2

C. Press DISPENSE to start ice bin dump. Press PAUSE
to halt dispensing as needed to dispose of ice.
Press RESUME to resume dispensing.
D. Dispense ice until bin is fully empty.
E. Remove ice dump chute and set aside.
F. Press NEXT once all ice is dispensed.
NOTE: Ice bin must be empty before pressing NEXT button.
8. Optional descaling of ice maker. Press NO.
9. Ice Maker Sanitation (See Figure 5)
A. Fill shaker jug with 1 gallon of luke warm water and
mix in approved sanitizer to appropriate ppm. (See
Figure 5)
B. Use key to unlock the top machine door.
C. Connect the CIP hose to the CIP pump quick
disconnect fitting. (See Figure 6)
D. Place other end of cleaning hose into shaker jug
with sanitizer mixture. (See Figure 6)
E. Select CONFIRM. Ice Sanitizer Soak countdown will
begin.
10. Prepare to rinse ice maker
A. Connect water supply line at rear of unit. (See
Figure 7)
B. Press CONFIRM to begin rinsing ice maker.
11. Ice Maker and Reservoir Evacuation
A. Disconnect the water supply line from the rear of
unit. (See Figure 8)
A. Press CONFIRM to begin draining water out from
the ice maker system.
NOTE: Water supply line must be disconnected from unit.
Ensure drain is connected.
12. Ice production cleanout
A. Connect water supply line at the rear of unit.
B. Disconnect cleaning hose from unit.
C. Use key to secure and lock upper door.
D. Press CONFIRM.
NOTE: System will make ice for 20 minutes to thoroughly
clean out system. The ice will need to be dumped out once
the production is complete.
13. Perform Ice Bin Dump. (See STEP 7)
14. System will make ice for 20 minutes to fill ice bin.
2 of 2
Document Number: MPX-i-005 08/1/19
FreshBlender Ice Maker Sanitation
FIGURE 5 - Mix Sanitizer
FIGURE 6 - Connect Cleaning Hose
FIGURE 7 - Connect Water Supply Line
FIGURE 8 - Disconnect Water Supply
FIGURE 9 - Ice Production Cleanout