Climax Technology SDCO-1-RhTH-ZW-SC-AC Manual

Smoke and Carbon Monoxide Detector
(SDCO-1-RhTH-ZW-SC-AC/SDCO-1-RhTH-ZW-SC-OTA-AC)

Introduction

SDCO-1-RhTH-ZW-SC-AC/SDCO-1-RhTH-ZW-SC-OTA-AC is a Z-Wave Smoke and Carbon Monoxide Detector with
temperature, humidity, and heat detection, as well as voice prompts and allows access to the "S2 Unauthenticated" class. It is
capable of sending wireless signals to the Z-Wave gateway/control panel upon detection of smoke particles or Carbon Monoxide.
The device is also serially connected with other sensors in the Z-Wave gateway to serve as an extra siren. When any other
sensor in the Z-Wave network is activated and sends an alarm signal, the Smoke Detector will also raise alarm with its built-in
buzzer as a siren to help sound warning (for serial connection models).
The SDCO-1 is designed to be mounted on ceiling or top of stairwells when smoke would concentrate to raise alarm timely and
protect your home from fire hazards.
The SDCO is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network. Z-Wave is a wireless
communication protocol that uses a low-power RF radio.

Parts Identification

1. Speaker
2. Button
 Press the button once to send an alarm test, temperature and humidity signals / test Smoke and Carbon Monoxide Detector.
 Press the button once during alarm to silence the alarm.
 Press the button 3 times within 1.5 seconds to send an inclusion code.
 Press and hold the button for 10 seconds. Release the button when you hear 2 beeps to enter smoke calibration and CO self-diagnosis
.process.
 Press and hold the button for 20 seconds. Release the button when you hear 3 beeps to perform factory reset.
 Press the button twice before inserting new batteries.
3. LED Indicator
Red LED
 Turns ON briefly: Transmitting signal.
 Quick flash: Alarming.
 Flashes every second: In Alarm Silence Mode.
 Flashes every 2 seconds: Under warmup and calibration process.
Amber LED
 Flash every second: Device power on/Calibration failed.
 Flashes every 5 seconds: Auto-calibration/self-diagnostic has failed.
 Flashes every 45 seconds: Low battery condition
Both Red and Amber LED (Orange when looking from the outside)
 Turns ON: Temperature/ Humidity sensor failed.
 Flashes every 4 seconds: Battery exhausted.
4. Buzzer
5. Mounting Holes (for Hooks)
The Hooks of the Mounting Bracket can hook into this Mounting Hole.
6. Mounting Bracket
7. Internal Tamper
8. Battery Compartment Cover
9. Battery Switch
10. Pre Punched Hole for Wiring
1