Makita BUX360 Instruction Manual page 9

Battery remaining capacity indicator
(only for models with Battery
BL3622A)
Battery BL3622A is equipped with the battery remaining
capacity indicator.
1
2
1. Indicator lamps 2. CHECK button
Press the CHECK button to indicate the battery remain-
ing capacity. The indicator lamps will then light for
approx. three seconds.
Indicator lamps
Lighted Off Blinking
E
• When only the lowermost indicator lamp (next
to the "E") blinks, or when none of the indicator
lamps light, the battery capacity has run out, so
the tool does not operate. In these cases, charge
the battery or replace the empty battery with a fully
charged one.
• When two or more indicator lamps do not light
even after charging is complete, the battery has
reached the end of its service life.
• When the upper two and lower two indicator lamps
light alternately, the battery may have malfunc-
tioned. Contact your local Makita authorized ser-
vice center.
NOTE:
• The indicated capacity may be lower than the
actual level during use or immediately after
using the tool.
• Depending on the conditions of use and the
ambient temperature, the indication may differ
slightly from the actual capacity.
Remaining capacity
70% to 100%
F
45% to 70%
20% to 45%
0% to 20%
Charge the battery.
The battery may have
malfunctioned.
ASSEMBLY
WARNING:
• Always be sure that the tool is switched
off and battery cartridge is removed before
carrying out any work on the tool. Failure to
switch off and remove the battery cartridge may
result in serious personal injury from accidental
start-up.
• Never start the tool unless it is completely
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Installing the grip
► Fig.6: 1. Grip 2. Clamp 3. Barrier 4. Spacer 5. Arrow
mark
Securely fit the barrier and grip onto the shaft pipe with
two screws and clamps.
Make sure that the grip/barrier assembly is located
between the spacer and the arrow mark. Do not remove
or shrink the spacer. Once assembled, do not remove
the barrier.
CAUTION:
• Never install the grip on the label or joint.
NOTE:
• In some countries, the barrier and spacer are
not provided with the tool. In that case, align the
handle to further side of the line which is indi-
cated by the arrow marks.
Mounting the attachment
► Fig.7: 1. Lock lever 2. Pin 3. Arrow mark 4. Release
button
To mount the attachment to a power unit:
1. Make sure that the lock lever is not tightened.
2. Align the pin with the arrow mark.
3. Insert the shaft into the drive shaft of the power
unit until the release button pops up.
4. Tighten the lock lever firmly as shown.
To remove the attachment, loosen the lock lever, press
the lock button and withdraw the shaft.
NOTICE:
• Do not tighten the lock lever without the shaft of
the attachment inserted. Otherwise the lock lever
may tighten the entrance of the drive shaft too
much and damage it.
Attaching shoulder harness
► Fig.8
Put the shoulder harness on your left shoulder by put-
ting your head and right arm through it. Keep the tool on
your right side.
After putting the shoulder harness, attach it to the tool
by connecting the buckles provided on both the tool
hook and the harness. Be sure that the buckles click
and lock completely in place.
Adjust the strap to the suitable length for your operation.
► Fig.9
9 ENGLISH