Yamabiko shindaiwa SBA-LE24 Operator's Manual page 13

Mount the cutting attachment shield on the gearcase
1. Shaft bolt
2. Bolt guard
3. Holder B
1. Cutting attachment
shield assembly
1. Bolts
2. Washers
1. Holder A
1. Shaft bolt
2. Bolt guard
4. Holder A
5. Gearcase
2. Gearcase
3. Nuts
2. Output shaft
3. Holder B
4. Blade
Before you start
1. Remove the shaft bolt, bolt guard, holder A and holder B
from the gearcase.
2. Align the cutting attachment shield assembly with the gear-
case as shown, and then fit the shield onto the matching
flange on the gearcase.
The edger is intended for right-handed operation only.
When correctly assembled, the cutting attachment
shield and shaft must be oriented as shown.
3. Install the bolts with washers. Firmly tighten all three bolts.
4. Install a washer and nut on each of the three bolts assem-
bled in Step 3, then firmly tighten each nut.
IMPORTANT
The three bolts must be firmly tightened against the cutting at-
tachment shield before installing and tightening the nuts.
Mount the Blade
1. Install the holder A onto the output shaft.
2. Mount the blade and holder B onto the output shaft, and then
install the bolt guard and shaft bolt (turn bolt counterclock-
wise to install).
3. Align the hole in holder A with the matched hole in the gear-
case, and then use the L-wrench to temporarily lock the out-
put shaft.
11
WARNING