Connecting Headphones; Using The Headphones Hook; Turning The Power On And Off; Adjusting The Sound's Volume And Brilliance - Roland HP103e Owner's Manual

Connecting Headphones

The HP103e/102e has two jacks for plugging in headphones.
This allows two people to listen through headphones simul-
taneously, making it very useful for lessons and when per-
forming piano pieces for four hands. Additionally, this
allows you to play without having to worry about bothering
others around you, even at night.
Plug the headphones into the Phones jack located
at the bottom left of the piano.
When headphones are connected, the [
indicator (p. 6) lights up, and sounds stop playing from
the speakers of the HP103e/102e.
The headphone volume is adjusted by the [Volume] knob
(p. 9) of the HP103e/102e.
Phones jack x 2
Use Stereo headphones.
Some notes on using headphones
• To prevent damage to the cord, handle the headphones only
by the headset or the plug.
• Connecting the headphones when the volume of connected
equipment is turned up may result in damage to the head-
phones. Lower the volume on the HP103e/102e before plug-
ging in the headphones.
• Listening at excessively high volume levels will not only
damage the headphones, but may also cause hearing loss.
Use the headphones at a moderate volume level.
I Using the Headphones Hook
Whenever you are not using the headphones, you can
hang them on the headphone hook at the lower left of the
HP103e/102e.
Attaching the Headphone Hook
Press and twist the headphone hook included with the
HP103e/102e into the hole in the bottom of the HP103e/
102e (refer to the figure below). Turn the wing nut of
headphone hook to secure the headphone hook.
Wing Nut
Headphone Hook
Turning the Power On and
Off
Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
To turn the power on, turn the [Volume] knob all
the way down, and then press the [Power On]
switch.
(Headphones)]
The power will turn on, and the Power indicator at the
left front of the HP103e/102e will light.
After a few seconds, you will be able to play the keyboard
to produce sound.
Use the [Volume] knob to adjust the volume.
NOTE
fig.00-06.e
Power On
Power Indicator
To turn the power off, turn the [Volume] knob all
the way to the left, and press the [Power On]
switch.
The Power indicator at the left front of the HP103e/102e
will go dark, and the power will be turned off.
NOTE
Adjusting the Sound's
Volume and Brilliance
Turn the [Volume] knob to adjust the overall vol-
ume.
Press the [Brilliance] button to adjust the bright-
ness of the sound.
Select one of the three available settings to obtain the
desired brilliance.
[Brilliance]
button's indicator
fig.00-07.e
Before You Start Playing
This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required
before the unit will operate normally.
If you need to turn off the power completely, first turn
off the POWER switch, then unplug the power cord
from the power outlet. Refer to "Power Supply" (p. 4).
Off
Brilliance Medium
Min Max
Lit in
Lit in red
green
Mellow Bright
9