Table of Contents
Advertisement
Available languages
Available languages
PARTS
(4 supplied)
(2 supplied)
Optional
Hose & Hose Clamp
CAC157
6
INSTALLATION
Carefully remove the pasta cooker from the packaging and place the
unit on a firm, level surface.
Insert the basket hanger into the two holes in
the brackets, located in the rear of the unit.
Use only the baskets provided with the unit.
DO NOT substitute the baskets or attempt
to replace the baskets.
This unit is to be installed with adequate backflow protection to comply
with applicable federal, state, and local codes.
This unit can also be used as a stand-alone, without external plumbing
connections.
STAND ALONE INSTRUCTIONS FOR INSTALLATION
Make sure all three valves are in the closed position. There are two
located in the front of the unit and one located on the back of the
unit. Fill unit with a bucket of tap water up to the max fill line (just
below the overflow drain).
PLUMBED INSTRUCTIONS FOR INSTALLATION
Connect the WATER REFILL inlet to the supply side and the WATER
OVERFLOW outlet) located on the back of the pasta cooker) to drain
side of the plumbing, using appropriate hardware (not supplied).
The refill plumbing connection is a male NPT ½. The overflow
plumbing connection is a female NPT ½.
If connecting to an outside water line, the plumbing connections must
contain water pressurized at or below Water Line Pressure and at or
below 40˚C (104˚F) during normal operation. If using a rubber hose:
It must have a Reinforcing Outer Braid, and have a manufacturer's
rating of at least 200 psig.
Make sure the water overflow outlet valve (located on back of pasta
cooker) is in the closed position. Open the water refill valve (located
on the front of the pasta cooker) to fill the basin with water. The valve
can be adjusted between open and close positions to control the
water flow into the basin.
BACK
Rear of Unit
FRONT
7
Advertisement
Table of Contents
